3D Printer Set for Mega 2560 R3 with A4988 Stepper Motor Drivers

This 3D printer accessory set is built around a Mega 2560 R3 board and a RAMPS 1.4 controller shield, supplied with A4988 stepper motor driver modules and heatsinks. The modular design uses plug-in stepper drivers and extruder control electronics on the shield, so parts can be replaced, serviced or upgraded easily. An indicator light shows when the heater output is on. Suitable for Reprap builds, with a memory card add-on available. The boards are made of printed circuit board material and are powered by DC low voltage only, not mains electricity. Total set weight is approximately 172g.

What's in the box
5 x A4988 Chip Board, 5 x Heating Panel, 1 x RAMPS 1.4 Boards Set (8 In Total), 1 x USB Cable, 1 x 2560 R3, 1 x for Mega 2560