Protect The Battery
Using this car battery kill switch can avoid power consumption due to long-term parking, a good point of electronic equipment, line ageing, forgetting to turn off the light, etc. It can effectively protect and prolong the life of the car battery. It can effectively protect and prolong the life of car batteries.
Easy To Install
The power off switch adopts negative connection mode, which is simple to install and more stable in performance. Please note: before installation, be sure to turn off the power supply and conduct ignition test after installation.
Electric leakage display
After the flameout, turn off the headlights, position lights and car doors to check the leakage situation. The "Low" indicator light is on, indicating that the leakage is medium (about 0.5A-2A); The "Mid" light is on, indicating that the leakage is serious (about 2-5A). The "High" light is on, indicating that the leakage is serious (above 5A).
Automatic cut-off
If the voltage is lower than 6V, the remote disconnect switch will automatically cut off the power supply after 120s to save power; if the voltage is higher than 30V, the remote control will be disabled to prevent the power supply from being turned off accidentally while driving, and the power supply can only be controlled by the button on the switch.
Widely Application
This automatic kill switch suit for most 12V cars, boats, RVs, trailers, trucks, ATVs, UTVs, motorcycles etc. It is not suitable for cars that can't change batteries when power is cut off, imported cars that will give an alarm when power is cut off and cars without spare mechanical keys are not recommended for installation.
Remote control matching instructions
Press the manual button on continuously, and the code indicator flashes three times in 3 seconds to enter the learning state of interlocking mode. Press any button on the remote controller, and the indicator flashes three times; The buzzer rang 3 times, and the code was successfully checked; Press and hold the manual buttON on for a long time, and the code indicator will flash for 8 times to indicate the completion of code clearing; The device can store up to 20 different remote control codes.

Product Parameter:
1. Working temperature -20 degrees-+100 degrees
2. Rated current of the switch is 250A.
3. switching instantaneous current 500A a.
4. The protection threshold for power failure is 11.6V+-0.2V/23V+-0.2V.
5. power loss delay 60 seconds alarm, 120 seconds automatic disconnection.
6. Standby current is 700uA

What's in the box
1 x Car Battery Isolator
2 x Remote Controller