DC12V 10A 1CH 433MHz Wireless Relay RF Remote Control Switch Receiver

Specification:
Input Voltage: DC10-14V
Standby Current: <5MA
RF Frequency: 433MHz
RF Working mode: Superheterodyne receiver
Receiver Sensitivity: >90dBm
Remote Control Distance: >100 meter(In open environment)
Decoding Way: MCU Software decoding
Can store the number of remote controls:50
Support remote control type: Fixed code, learning code
Channel: 1CH
Multiple working modes: (Jog/Non-Latched,inter-lock/Latched,self-lock /Self-Latched, Delay off)
Wiring Method: Fixed wiring terminal
Working Voltage: DC12V
Output Current: 10A
Rated load:10A 250VAC / 10A 125VAC
A 30VDC / 10A 28VDC
Output: Normally open, Common, Normally closed
Dimension:3.5cmx3cmx1.6cm

Description:
Jog: Press the learning button, then release. Set the mode from the system automatically working mode to action mode, wait for a while, when the board LED turns off, said it is in the learning state. Press the remote control; the system receives the signal. The LED flashes 5 times and goes off again. After 3S delay, LED lights up to mark learning success; the system automatically withdraws from the learning state.

Self-locking: Press the learning button, then release, press 2 times, the system automatically sets to self-locking mode, wait for a while, LED off, it is into the learning state,

Press the remote control, LED flash 5 times Off. 3S after the delay, LED light learning success.

Interlock: Press the learning button, then release, press 3 times in succession, the system is set to interlock mode.

Delay: Press the remote control relay pull-in, release the remote control and begin timekeeping. After 5s,10s,15s will automatically close the relay.

What's in the box
5 x 12V 1CH 433MHz Wireless Relay Switch Receiver