K20 to K24 Crankshaft Sensor Conversion Harness for Engine Swap

K20 to K24 Crankshaft Sensor Conversion Harness for Engine Swap

Plug-And-Play K20 To K24 Crank Sensor Adapter Harness For Stable Engine Signal

R 417.00

Takealot · checked Today

View at Takealot
Average
R 417.00
Lowest seen
R 417.00
Highest seen
R 417.00
Last change
R 0.00
First indexed
20 Nov 2026
Retailer
Takealot

Description

This Crankshaft Sensor Conversion Harness Is Built For K20 To K24 Engine Swaps, Letting DIY Builders And Daily Drivers Run A K24 Crank Sensor On A K20 Setup Without Rewiring The Engine Harness. Use It When A Mismatched Plug Causes Rough Idle, Hard Starts, Or Misfire Codes. The Camshaft Position Sensor Connector Feed Camshaft And Crankshaft Position Signals Directly To The ECU, So The Engine Control System Reads Timing Accurately. An Optimized Circuit Path Supports Accurate, Stable Signal Output, And Quality Connections With Precision Electronics Support Engine Responsiveness And Vehicle Stability. The Housing Is High Strength ABS With Metal Terminals, Built As A Wear Proof Plug And Play Jumper That Holds Up To Engine Bay Heat And Vibration Instead Of Loosening At The Pins. This Harness Fits K20 To K24 Swaps Only, Not Other Engine Families. It Suits DIY Swappers And Street Driven Cars; It Is Not Intended For Other Engine Families Or For Race-Only Builds Needing A Custom Loom. Check Your Factory Plug Shape Against The Connector Before Ordering. No Splicing Or Pin Re-Pinning Is Needed, So First-Time Swappers Skip Crimping Work And The Circuit Stays Stable After Installation. Specifications:
- Item Type: Crankshaft Sensor Conversion Harness
- Material: ABS Housing With Metal Terminals
- Function: Converts A K20 Crankshaft Sensor Signal To K24 Crank Sensor Input
- Fitment: K20 To K24 Engine Swaps
- Installation: Plug And Play, No Splicing Or Pin Re-Pinning Packing List:
- 1 X Crankshaft Sensor Conversion Harness

What's in the box
1 x Crankshaft Sensor Conversion Harness

Similar products