Kingston ValueRam Memory DDR3-1600 - 8GB DIMM

KINGSTON VALUERAM 8GB DDR3-1600 DIMM - Desktop Ram

KVR16N11/8

8GB 2Rx8 1G x 64-Bit PC3-12800

CL11 240-Pin DIMM - Desktop

This document describes ValueRAM's 1G x 64-bit (8GB) DDR3-1600 CL11 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. This 240-pin DIMM uses gold contact fingers. Desktop RAM

Features:

JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply

VDDQ = 1.5V (1.425V ~ 1.575V)

800MHz fCK for 1600Mb/sec/pin

8 independent internal banks

Programmable CAS latency: 11, 10, 9, 8, 7, 6

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

8-bit pre-fetch

Burst Length: 8 (interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write (either on the fly using A12 or MRS)

Bi-directional Differential Data Strobe

Internal (self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm 1%)

On Die Termination using ODT pin

Average Refresh Period 7.8us at lower than TCASE 85 C, 3.9us at 85 C < TCASE < 95 C

Asynchronous Reset

PCB: Height 0.740" (18.75mm) or 1.180" (30.00mm)

Specifications:

CL(IDD) : 11 cycles

Row Cycle Time (tRCmin) : 48.125ns(min.)

Refresh to Active/Refresh : 260ns(min.)

Command Time (tRFCmin)

Row Active Time (tRASmin) : 35ns(min.)

Maximum Operating Power : TBD W

UL Rating : 94 V - 0

Operating Temperature : 0o C to +85o C