LinkQnet 1KVA XR Online Tower UPS

LinkQnet 1KVA XR Online Tower UPS The LinkQnet 1kVA XR Online Tower UPS provides continuous power conditioning for compatible computers, networking hardware and other sensitive electronic equipment. Its true online double-conversion design delivers a regulated pure sine wave output with no transfer delay when moving from mains power to battery operation. This extended-run model uses an external 24 V battery solution, allowing the battery capacity to be selected according to the required backup time. Please note that batteries are not included and must be correctly specified and installed for the intended application. Continuous Power Protection Online double-conversion technology isolates connected equipment from common mains power disturbances while maintaining a stable output. The UPS supports selectable 208, 220, 230 or 240 V output and regulates output voltage to within ±1%. Flexible Installation and Monitoring A wide 110–300 V AC input range helps the UPS continue operating through varying utility conditions, while generator compatibility supports alternative power arrangements. Its LCD interface displays essential operating information, including input and output values, load percentage, battery voltage, internal temperature and estimated remaining backup time. Key Features: 1,000 VA / 900 W capacity for compatible IT, networking and electronic equipment. True online double-conversion topology provides a pure sine wave output and 0 ms mains-to-battery transfer time. Extended-run design works with a separately purchased external 24 V battery solution. Wide 110–300 V AC input range provides greater tolerance of fluctuating utility power. Selectable 208, 220, 230 or 240 V AC output supports different installation requirements. LCD monitoring, ECO mode, generator compatibility and cold-start capability provide flexible operation. Built-in protection covers short circuits, overload, overheating, battery overcharge and over-discharge, low output voltage and fan faults. Important Battery Information: This UPS is supplied without batteries. A compatible external 24 V battery solution is required for backup operation. Available runtime depends on the connected load and the capacity and condition of the selected batteries. Battery selection and installation should be completed by a suitably qualified installer. Technical Specifications: Specification Details General Brand LinkQnet Model 1kVA 24V XR Online Tower UPS SKU / MPN UPS-ONL-1KVA-X-K Product Type Extended-run online tower UPS Topology Online double conversion with full digital control Rated Capacity 1,000 VA / 900 W Output Waveform Pure sine wave Input Nominal Input Voltage 208 / 220 / 230 / 240 V AC Input Voltage Range 110–300 V AC; 176–280 V AC at 100% load Input Frequency Range 40–70 Hz with 50/60 Hz auto-sensing Input Power Factor ≥0.99 with power factor correction Output Selectable Output Voltage 208 / 220 / 230 / 240 V AC Output Power Factor 0.9 Voltage Regulation ±1% Output Frequency — Line Mode 46–54 Hz or 56–64 Hz Output Frequency — Battery Mode 50/60 Hz ±0.1% Crest Factor 3:1 Harmonic Distortion ≤3% with a linear load; ≤5% with a non-linear load AC-to-Battery Transfer Time 0 ms Inverter-to-Bypass Transfer Time 4 ms typical Efficiency and Battery System AC Mode Efficiency 88% Battery Mode Efficiency 85% Battery System Voltage 24 V DC Battery Configuration External battery solution required Batteries Included No Cold Start Supported with a suitable connected battery system Monitoring and Protection LED Indicators Line, battery, ECO and bypass modes; low battery, overload and UPS fault LCD Information Input voltage and frequency, output voltage and frequency, load percentage, battery voltage, internal temperature and estimated backup time Standard Communication RS-232 Optional Interfaces USB, EPO, relay card and SNMP card Operating Modes Online, battery, bypass and ECO modes Protection Functions Short-circuit, overload, overheating, battery overcharge, battery over-discharge, low output voltage and fan fault protection Operating Environment and Standards Operating Temperature 0–40°C Storage Temperature -25–55°C Relative Humidity 20–95% RH at 0–40°C, non-condensing Operating Altitude Up to 1,500 m Noise Level <50 dB at 1 m Safety Standards IEC/EN 62040-1 and IEC/EN 62477-1 EMC Standards IEC/EN 62040-2; IEC 61000-4-2, -4-3, -4-4, -4-5, -4-6 and -4-8 Protect compatible office and networking equipment with continuous online power conditioning by adding the LinkQnet 1kVA XR UPS and a correctly specified external battery solution to your setup.