SA Low Pressure Bullnose Regulator

• This low-pressure regulator is designed to supply gas to low-pressure appliances at a pressure of 2.8kPa and at the capacity indicated on the identification label (1)
• The regulator is suitable for any size cylinder with a 5/8" BSP left-hand thread (Bullnose fitting) This regulator is for use with LPG only (liquefied petroleum gas)
• The gas cylinder must always be used in an upright position. When used outdoors the regulator must be suitably protected against rain.
• Attach a suitable length of SANS approved gas hose (3) to the hoze nozzle (2) and secure the hose with a hose clamp (4)
• Connect the regulator to the gas cylinder by attaching the regulator handwheel (5) to the valve opening (7) and turn this handwheel anticlockwise (8)
• The handwheel should be tightened completely by hand into the cylinder valve
• There is no need to use any tool. Also, be sure to turn the handwheel only while holding the regulator body steady; the regulator is NOT to be turned
• Open the gas supply by turning the cylinder valve handle (9) anticlockwise and test for leaks by brushing with a soapy water solution onto the regulator and joints. The formation of bubbles will indicate a gas leak. Never test for leaks with a match or naked flame!
• Whenever you replace your gas cylinder, be sure to check for the presence and condition of the rubber washer (6) in front of the handwheel.
• INSTALL UNDER PROTECTIVE COVER WHEN INSTALLING OUTDOORS

What's in the box
1 x SA Low Pressure Regulator