Sound Card 48V Phantom Power2 Channel XLR Preamp Loopback Internal Record
XGESaudio,JOJOaudio,2i2Sounccard,Recording soundcard,Microphone audio specialty store, shipped from local
Takealot · checked 4 days ago
3 offers · 2 retailers
Listed under the same model number
No barcode ties these listings together, so no saving is claimed. See the listings
Matched by model number; no shared barcode
- Average
- R 2 888.00
- Lowest seen
- R 2 888.00
- Highest seen
- R 2 888.00
- Last change
- R 0.00
- First indexed
- 29 Oct 2026
- Retailer
- Takealot
Description
Plug & Play No driver installation required, connect via USB to Windows / Mac computer directly.
2 XLR Combo Inputs Support dynamic mic, condenser mic, guitar and instrument. Independent GAIN gain adjustment for each channel.
48V Phantom Power Built-in 48V phantom power supply for condenser microphones.
Low Cut & Loopback Low Cut filter to reduce low-frequency rumble noise; Loopback function for internal recording, capture computer audio for live streaming & podcast.
Zero Latency Monitoring 6.35mm headphone jack, independent volume knob for real-time monitoring.
Audio Specification 24Bit / 192kHz high sampling rate, restore clear studio sound quality.
Dual Output Independent line output for speakers, separate control for monitor and DAW signal.
Operation InstructionsStep1 Hardware Connection
1. Connect the audio interface to your computer with USB cable. Power on the device.
2. Plug microphone / guitar into INPUT 1 / INPUT 2 combo jack.
3. Plug headphones into PHONES jack, or connect speakers to OUT port.
Step2 Adjust Settings
1. Turn GAIN knob to adjust input signal level. Watch SIG / PK indicator, avoid red PK overload light.
2. Turn on 48V phantom power only when using condenser microphones. Turn off 48V for dynamic mics.
3. Switch Low Cut on to cut low-frequency noise (floor vibration, wind noise).
4. MIX knob: balance MONITOR direct sound and DAW software playback sound.
5. OUT knob: control line output volume for speakers.
6. PHONES knob: adjust headphone listening volume.
Step3 How to use Loopback
Turn on Loopback switch, the sound playing on your computer can be recorded together with microphone audio. Suitable for live streaming, podcast, recording online meeting audio.
Step4 Software Setup
Open your recording software (DAW: Audacity, Reaper etc.), select this USB Audio Interface as input & output audio device.
Troubleshooting
No sound: Check USB connection, select correct audio device on computer.
Distortion / crackle: Reduce GAIN gain, PK light should not stay red.
Condenser mic no sound: Turn on 48V phantom power.
What's in the box
1 x Soundcard
1 x Usb Cable
