Upgraded Nanovna-H Vector Network Antenna Analyzer Compatible with None

Upgraded NanoVNA-H Vector Network Antenna Analyzer 10KHz-1.5GHz MF HF VHF UHF for SD Card Slot Digital NanoVNA Tester

1. Lower power supply noise, less noise when using harmonics;
2. Built-in 400mAh battery
3. Add a Micro-SD card to save the test data;
4. Add RTC support;
5. Modify the port names to Port1 and Port2
   Measurement Frequency: 10KHz -1.5GHz
   RF Output: -13dbm (maximum -9dbm)
   Frequency Accuracy: Less than 0.5ppm
   Measurement Range: 70dB (50kHz-300MHz), 50dB (300M-600MHz), 40dB (600M-900MHz) enable extended firmware)
   Port SWR: Less than 1.1
   Display: 2.8 inch TFT (320 x240)
   USB Interface: USB Type-C; Communications Mode: CDC (Serial)
   Power Supply: USB 5V 120mA, built-in 650mAh electricity, maximum charging current 0.8A
   Number of Calibration Points: 101 (Fixed)
   Number of Scanning Points: 101 (Fixed)
   Display Tracking: 4, Marking: 4, Save Setting : 5
   Measuring S parameters, voltage standing wave ratio, phase, delay, Smith chart and the like
   Colour:black
   Material:Metal + Plastic
   Package Contents:
   1 x NanoVNA host (including 2.8-inch touch screen, 400mAh battery)
   2 x 20cm SMA male to male RG174 RF cable
   1 x SMA female to female connector
   1 x SMA Simple Calibration Kit SHORT
   1 x SMA Simple Calibration Kit OPEN
   1 x SMA Simple Calibration Kit LOAD
   1 x USB Type-C data cable
   1 x Touch pen
   1 x Picks
   Only the above package content, other products are not included.
   Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.

What's in the box
1 x Nanovna Host (Including 2.8-Inch Touch Screen, 400Mah Battery)
2 x 20Cm Sma Male To Male Rg174 Rf Cable
1 x Sma Female To Female Connector
1 x Sma Simple Calibration Kit Short
1 x Sma Simple Calibration Kit Open
1 x Sma Simple Calibration Kit Load
1 x Usb Type-C Data Cable
1 x Touch Pen
1 x Picks