Water Pump Compatible with Corolla /Conquest 160i 93-(4afe/5afe)
Takealot · checked 5 days ago
- Average
- R 498.40
- Lowest seen
- R 305.00
- Highest seen
- R 843.00
- Last change
- R 195.00
- First indexed
- 23 Sep 2026
- Retailer
- Takealot
Description
Water Pump - OEM-Spec Replacement
Maintain correct coolant flow and stable operating temperature with an OEM-spec water pump. This unit is matched to your vehicle's application (mechanical or electric, depending on model) for reliable cooling and long-term durability.
Why replace the water pump:
- Restores correct coolant circulation to prevent overheating
- Protects head gasket, radiator, thermostat and hoses from heat stress
- OEM-aligned design for proper fitment and seal integrity
- Supports efficient heater performance and stable cabin temperatures
- Pump type overview
Mechanical water pump:
- Driven by belt or timing chain via pulley
- Wear points: bearings, seals, impeller and gasket surfaces
- Typical failures: coolant leaks, bearing noise, reduced flow causing overheating
Electric water pump:
- ECU-controlled motor adjusts flow as required by the engine
- Wear points: motor brushes (if applicable), electronics, and seals
- Typical failures: intermittent or no operation, overheat warnings, or limp-mode events
- Common symptoms of a failing pump
- Coolant leaks or a sweet smell near the pump area
- Grinding or whining noises increasing with engine speed (mechanical)
- Temperature gauge spikes, overheating warnings, or coolant light
- Heater blowing cold at idle, then warm at higher RPM (low coolant flow)
- Images are for illustration. Always confirm by OE/part number or VIN where possible.
Installation best practice:
- Inspect and replace the drive belt and tensioner (mechanical pumps) if worn
- Use fresh, correct-spec coolant and bleed the system properly
- Clean gasket surfaces thoroughly and torque bolts to manufacturer specs
- For electric pumps, check wiring and perform the manufacturer bleed procedure
Coolant type and warranty importance:
Using the correct coolant is critical for pump performance and long-term engine protection. Mechanical and electric water pumps rely on clean, corrosion-inhibited coolant to lubricate seals and prevent cavitation damage. Mixing coolants or using plain tap water can lead to premature bearing failure, seal leaks, and corrosion inside the block and radiator.
Always use manufacturer-approved synthetic coolant such as G12 or G12++ (depending on the vehicle specification) and mix only with deionised or distilled water. Using incorrect or contaminated coolant can reduce pump life and may void your warranty.
What's in the box
1 x Water Pump
Similar products
Takealot
Electronic Water Pump Compatible With BMW #N55
Takealot
Auxiliary Water Pump Compatible with Audi/VW - 5N0965561A
WiIdHaven
Water Pump Pulley Compatible with Mini Cooper
GMB
GMB GWT-93A Water Pump Compatible Toyota Tazz Corolla Conquest 1.3
Takealot
BMW, MINI Compatible Water Pump N13, N14, N18
5.0(1)Takealot
Water Pump Pulley Compatible With Suzuki Alto K10B
WiIdHaven
Engine Water Pump 210107Y026 Compatible with Infiniti G25
Takealot
M156 Water Pump 1562000601 Compatible With Mercedes Benz
WiIdHaven
Outboard Water Pump Impeller Kit Compatible with Mariner
SWGE
Auxiliary Water Pump Compatible with VW Amarok 2.0 Tdi
4.6(5)GMB
GMB GWM-52A Water Pump Compatible Pajero, Delica, Challenger, Hyundai
WOVIBO