M10x1.25 Motorcycle Brake Bleed Screw Aluminum Caliper Nipple For Front

This M10x1.25Mm Motorcycle Brake Caliper Bleed Screw Is A Replacement Bleeder Valve For Front Or Rear Brake Calipers And Master Cylinders On Motorcycles That Accept This Thread Pitch, Used To Purge Trapped Air When Brake Lever Feel Turns Spongy. The Body Is Machined From Aluminum With An Anodized Red Finish That Resists Rust And Corrosion From Brake Fluid And Road Moisture, Measures 47Mm (1.8In) In Overall Length, And Weighs Approximately 20G; Two Washers Are Included To Seal The Bleeder Seat Against Leaks. If Your Brake Lever Feels Soft Or Travels Further Than Usual, Air Is Likely Trapped In The Line. This Bleed Nipple Lets You Release That Air From The Front Or Rear Brake Lines And From The Back Of The Master Cylinder, Where Air Tends To Collect, Helping Restore Firm Lever Response. It Suits DIY Garage Bleeding And Roadside Air Purging For Home Mechanics And Daily Riders Working On Their Own Machines. Compared With Plain Steel Bleeders That Corrode And Seize In The Caliper Over Time, The Anodized Aluminum Body Offers A Lighter, Corrosion-Resistant Alternative At 20G Per Unit, And The Included Washers Create A Sealing Surface At The Bleeder Seat Rather Than Relying On The Threads Alone. It Fits Calipers And Master Cylinders Threaded M10x1.25 Only. It Is Not For Systems Using Other Thread Pitches, ABS Service Ports, Or Professional Racing Brake Setups. Verify Your Port Matches M10x1.25 Before Ordering, Then Seat The Screw With The Supplied Washers And Tighten Gently, Since Aluminum Threads Can Strip If Over-Tightened. Specifications:
- Material: Aluminum, Anodized Finish
- Thread Size: M10x1.25Mm
- Length: 47Mm (1.8In)
- Weight: Approx. 20G
- Fitment: Universal For M10x1.25 Ports
- Color: Red Packing List:
- 1 X M10x1.25Mm Bleed Screw
- 2 X Washers

What's in the box
1 x M
10 x 25Mm Bleed Screw
1 x Dust Cap
2 x Washers