Universal Motorcycle Rear Brake Light Switch M10x1.25 For Suzuki

This M10x1.25 Hydraulic Brake Light Switch Is Made For Riders With A Single Line Hydraulic Brake System On Standard Rear Sets, Including Most Suzuki Motorcycles. It Replaces The Pressure Switch In Your Rear Brake Circuit So Your Brake Light Works Again Without Changing The Whole Rear Set. The Body Is Aluminum With A Black Finish, And The Hollow Bolt Measures 32 X 10 Mm (1.26 X 0.4 In). The 10 Mm Bolt Diameter And 1.25 Mm Thread Pitch Match M10x1.25 Single Line Fittings. Two Install Washers Are Included To Seal The Hollow Bolt Against Fluid Leaks, And The Whole Unit Weighs About 36 G. When You Press The Rear Brake, Brake Fluid Passes Through The Hollow Bolt And The Switch Closes The Circuit To Turn On Your Brake Light. The 40 Cm (15.7 In) Lead Reaches Typical Rear Set Positions, So You Can Route It Back To Your Existing Connector. This Switch Fits Single Line Hydraulic Rear Sets Only. It Is Not For Dual Line Setups, ABS Modulator Circuits, Or Banjo Bolts In Any Size Other Than M10x1.25. Check Your Thread Size And Line Layout Before Ordering. Specifications:
- Material: Aluminum, Plastic
- Main Color: Black
- Thread: M10 X 1.25 Mm
- Bolt Size: 32 X 10 Mm (1.26 X 0.4 In)
- Total Length: 40 Cm (15.7 In)
- Weight: Approx. 36 G
- Fits: Single Line Hydraulic Brake Systems, Most Motorcycles Including Suzuki Packing List:
- 1 X Hydraulic Brake Pressure Light Switch
- 2 X Washers Notes: Allow 0 To 1 Inch Difference Due To Manual Measurement. Professional Installation Is Recommended. New Type Or Old Type May Be Sent At Random.

What's in the box
1 x Hydraulic Brake Pressure Light Switch
2 x Washers